Cisco Nexus 5600 Series - Page 130

Show Commands
show routing multicast clients
MCR-126
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show routing multicast clients
To display information about IPv4 multicast routing clients, use the show routing multicast clients
command.
show routing [ip | ipv4] multicast clients [client-name]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 multicast clients:
switch(config)# show routing multicast clients pim
IP Multicast Routing Client information
Client: pim, client-id: 5, pid: 5296, mts-sap: 310
Shared-memory: pim, Notifications: joins prunes rpf delete repopulate
Protocol is ssm owner, bidir owner, shared-only mode owner,
Join notifications: sent 1, fail 0, ack rcvd 1
ip (Optional) Specifies IPv4 multicast clients.
ipv4 (Optional) Specifies IPv4 multicast clients.
client-name (Optional) One of the following multicast routing client names:
• mrib
• igmp
• static
• msdp
• ip
• pim
Release Modification
5.0(3)N1(1) This command was introduced.