158
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip igmp last-member-query-response-time
ip igmp last-member-query-response-time
To configure a query interval in which the software sends membership reports and then deletes the group
state, use the ip igmp last-member-query-response-time command. To reset the query interval to the
default, use the no form of this command.
ip igmp last-member-query-response-time interval
no ip igmp last-member-query-response-time [interval]
Syntax Description
Command Default The query interval is 1 second.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a query interval:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp last-member-query-response-time 3
switch(config-if)#
This example shows how to reset a query interval to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp last-member-query-response-time
switch(config-if)#
Related Commands
interval Query interval in seconds. The range is from 1 to 25. The default is 1.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip igmp interface Displays IGMP information about the interface.
To Next Page
Loading...
