Cisco Nexus 5600 Series - Page 165

161
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip igmp query-max-response-time
ip igmp query-max-response-time
To configure a query maximum response time that is advertised in IGMP queries, use the ip igmp
query-max-response-time command. To reset the response time to the default, use the no form of this
command.
ip igmp query-max-response-time time
no ip igmp query-max-response-time [time]
Syntax Description
Command Default The query maximum response time is 10 seconds.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a query maximum response time:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp query-max-response-time 15
switch(config-if)#
This example shows how to reset a query maximum response time to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp query-max-response-time
switch(config-if)#
Related Commands
time Query maximum response time in seconds. The range is from 1 to 25. The default is
10.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip igmp interface Displays IGMP information about the interface.