Cisco Nexus 5600 Series - hardware multicast snooping group-limit

196
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter H Commands
hardware multicast snooping group-limit
hardware multicast snooping group-limit
To configure the number of groups learned through IGMP Snooping, use the hardware multicast
snooping group-limit command.
hardware multicast snooping group-limit limit
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Before setting a new group-limit, you must either clear the MAC address table or clear the groups already
learned.
The unique OIFL (output interface list) combinations can only be 2000.
Use the vPC type-2 inconsistency to show the configuraitons on vPC peers.
A reload is not neccessary after configuring the group-limit.
This command does not require a license.
Examples This example shows how to set the maximum number of groups to 500:
switch(config)# hardware multicast snooping group-limit 500
switch(config)#
Related Commands
limit Number of groups learned through IGMP Snooping. The range is from 100 to 8000.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip igmp snooping
groups
Displays information about the group membership for IGMP snooping.