Cisco Nexus 5600 Series - Page 212

208
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip igmp snooping mrouter interface
ip igmp snooping mrouter interface
To configure a static connection to a multicast router, use the ip igmp snooping mrouter interface
command. To remove the static connection, use the no form of this command.
ip igmp snooping mrouter interface {ethernet slot/port | port-channel number[.sub_if_number]}
no ip igmp snooping mrouter interface {ethernet slot/port | port-channel
number[.sub_if_number]}
Syntax Description
Command Default None
Command Modes VLAN configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines The interface to the router must be in the selected VLAN.
This command does not require a license.
Examples This example shows how to configure a static connection to a multicast router:
switch(config)# vlan 1
switch(config-vlan)# ip igmp snooping mrouter interface ethernet 2/1
switch(config-vlan)#
This example shows how to remove a static connection to a multicast router:
switch(config)# vlan 1
switch(config-vlan)# no ip igmp snooping mrouter interface ethernet 2/1
switch(config-vlan)#
ethernet
slot/port
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
port-channel
number
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
sub_if_number (Optional) Subinterface number. The range is from 1 to 4093.
Release Modification
6.0(2)N1(1) This command was introduced.