Cisco Nexus 5600 Series - show ip igmp snooping

221
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip igmp snooping
show ip igmp snooping
To display information about IGMP snooping, use the show ip igmp snooping command.
show ip igmp snooping [vlan vlan-id]
Syntax Description
Command Default Displays all VLANs.
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about IGMP snooping for a VLAN:
switch(config)# show ip igmp snooping vlan 20
IGMP Snooping information for vlan 20
IGMP snooping enabled
Optimised Multicast Flood (OMF) disabled
IGMP querier none
Switch-querier disabled
IGMPv3 Explicit tracking enabled
IGMPv2 Fast leave disabled
IGMPv1/v2 Report suppression enabled
IGMPv3 Report suppression disabled
Link Local Groups suppression enabled
Router port detection using PIM Hellos, IGMP Queries
Number of router-ports: 1
Number of groups: 0
Active ports:
Eth1/21 Po100
switch(config)#
vlan vlan-id (Optional) Specifies a VLAN. The range is from 1 to 3967 and 4048 to 4093. The
default is all VLANs.
Release Modification
6.0(2)N1(1) This command was introduced.