Cisco Nexus 5600 Series - Page 275

271
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip msdp rpf
show ip msdp rpf
To display information about the Multicast Source Discovery Protocol (MSDP) next-hop autonomous
system (AS) on the Border Gateway Protocol (BGP) path to a rendezvous point (RP) address, use the
show ip msdp rpf command.
show ip msdp rpf rp-address [vrf {vrf-name all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about MSDP reverse path forwarding (RPF) peers:
switch(config)# show ip msdp rpf 192.168.1.10
rp-address IP address of the RP.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
6.0(2)N1(1) This command was introduced.