Cisco Nexus 5600 Series - Page 28

Show Commands
show forwarding distribution multicast route
MCR-24
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show forwarding distribution multicast route
To display information about the multicast Forwarding Information Base (FIB) distribution routes, use
the show forwarding distribution multicast route command.
show forwarding distribution [ip | ipv4] multicast route [table id | vrf vrf_name] [[group
{group-addr [mask] | group-prefix}] [source {source-addr [source-mask] | source-prefix}] |
summary]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
ip (Optional) Specifies IPV4 information.
ipv4 (Optional) Specifies IPV4 information.
table id (Optional) Specifies the multicast routing table ID. The range is from 0 to
2147483647.
vrf vrf_name (Optional) Specifies a virtual routing and forwarding (VRF) name. The name can be
a maximum of 32 alphanumeric characters.
group (Optional) Specifies an IPv4 multicast group.
group-addr IPv4 multicast group address.
mask (Optional) Mask for the group address.
group-prefix (Optional) IPv4 multicast group prefix.
source (Optional) Specifies an IPv4 multicast source.
source-addr IPv4 source address.
source-mask (Optional) Mask for the group address.
source-prefix (Optional) IPv4 multicast source prefix.
summary (Optional) Displays the route counts.
Release Modification
5.0(3)N1(1) This command was introduced.