Cisco Nexus 5600 Series - Page 297

293
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter C Commands
clear ipv6 mroute
clear ipv6 mroute
To clear routes in the IPv6 multicast routing table, use the clear ipv6 mroute command.
clear ipv6 mroute {* | group-prefix | group [source]} [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to clear all the routes in the IPv6 multicast routing table:
switch(config)# clear ipv6 mroute *
switch(config)#
Related Commands
* Specifies all routes.
group-prefix Group prefix.
group Group address.
source (Optional) Source (S, G) route.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name.
all Specifies all VRFs.
Release Modification
4.0(3) This command was introduced.
Command Description
show ipv6 mroute Displays information about the IPv6 multicast routing table.