Cisco Nexus 5600 Series - Page 299

295
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter C Commands
clear routing ipv6 multicast
clear routing ipv6 multicast
To clear the IPv6 multicast routing table, use the clear routing ipv6 multicast command.
clear routing ipv6 multicast {* | group-prefix | group [source]} [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to clear the IPv6 multicast routing table:
switch(config)# clear routing ipv6 multicast *
switch(config)#
Related Commands
* Specifies routes.
group-prefix Group prefix.
group Group address.
source (Optional) Source (S, G) route.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name.
all Specifies all VRFs.
Release Modification
4.0(3) This command was introduced.
Command Description
show routing ipv6
multicast
Displays information about IPv6 multicast routes.