Cisco Nexus 5600 Series - ip mroute

306
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter F Commands
feature pim
feature pim
To enable Protocol Independent Multicast (PIM), use the feature pim command. To disable PIM, use
the no form of this command.
feature pim
no feature pim
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Supported User Roles network-admin
VDC administrator
Command History
Usage Guidelines You must enable the PIM feature before you can configure PIM.
This command requires the LAN Base Services license.
Examples This example shows how to enable a PIM configuration:
switch(config)# feature pim
switch(config#
Related Commands
Release Modified
6.0(2)N1(1) This command was introduced.
Command Description
show
running-configuration
pim
Displays the PIM running configuration information.
show feature Displays the status of features on a switch.
ip pim sparse-mode Enables IPv4 PIM sparse mode on an interface.