Cisco Nexus 5600 Series - ip pim anycast-rp

308
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter H Commands
hardware profile multicast max-limit
hardware profile multicast max-limit
To set the maximum number of entries in the multicast routing table, use the hardware profile multicast
max-limit command.
hardware profile multicast max-limit max-entries
Syntax Description
Command Default None
Command Modes Global configuration mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Examples This example shows how to set the maximum number of entries in the multicast routing table to 3000:
switch(config)# hardware profile multicast max-limit 3000
Warning!!: The multicast and /32 unicast route limits have been changed.
Any route exceeding the limit may get dropped.
switch(config)#
Related Commands
max-entries Maximum number of entries in the multicast routing table. The range is from 0 to
16000.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show hardware profile
status
Displays information about the multicast routing table limits.