Cisco Nexus 5600 Series - Page 314

310
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip mroute
ip mroute
To configure multicast reverse path forwarding (RPF) static routes, use the ip mroute command. To
remove RPF static routes, use the no form of this command.
ip mroute {ip-addr ip-mask | ip-prefix} {{next-hop | nh-prefix} | {ethernet slot/port | loopback
if_number | port-channel number | vlan vlan-id}} [pref] [vrf vrf-name]
no ip mroute {ip-addr ip-mask | ip-prefix} {{next-hop | nh-prefix} | {ethernet slot/port | loopback
if_number | port-channel number | vlan vlan-id}} [pref] [vrf vrf-name]
Syntax Description
Command Default The route preference is 1.
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
ip-addr IP prefix in the format i.i.i.i.
ip-mask IP network mask in the format m.m.m.m.
ip-prefix IP prefix and network mask length in the format x.x.x.x/m.
next-hop IP next-hop address in the format i.i.i.i.
nh-prefix IP next-hop prefix in the format i.i.i.i/m.
ethernet
slot/port
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
loopback
if_number
Specifies the loopback interface. The loopback interface number is from 0 to 1023.
port-channel
number
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
vlan vlan-id Specifies the VLAN interface. The range is from 1 to 4094.
pref (Optional) Route preference. The range is from 1 to 255. The default is 1.
vrf vrf-name (Optional) Specifies the virtual routing and forwarding (VRF) context name. The
name can be any case-sensitive, alphanumeric string up to 32 characters.
Release Modification
6.0(2)N1(1) This command was introduced.