Cisco Nexus 5600 Series - Page 321

317
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim auto-rp rp-candidate
ip pim auto-rp rp-candidate
To configure an IPv4 Protocol Independent Multicast (PIM) Auto-RP candidate route processor (RP),
use the ip pim auto-rp rp-candidate command. To remove an Auto-RP candidate RP, use the no form
of this command.
ip pim auto-rp rp-candidate {ethernet slot/port | loopback if_number | port-channel number |
vlan vlan-id} {group-list prefix} {[scope ttl] | [interval interval] | [bidir]}
no ip pim auto-rp rp-candidate [{ethernet slot/port | loopback if_number | port-channel number
| vlan vlan-id}] [group-list prefix} {[scope ttl] | [interval interval] | [bidir]}
Syntax Description
Command Default The TTL is 32.
The Announce message interval is 60 seconds
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
ethernet
slot/port
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
loopback
if_number
Specifies the loopback interface. The loopback interface number is from 0 to 1023.
port-channel
number
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
vlan vlan-id Specifies the VLAN interface. The range is from 1 to 4094.
group-list
prefix
Specifies the group range used for the access list.
scope ttl (Optional) Specifies a time-to-live (TTL) value for the scope of Auto-RP Announce
messages. The range is from 1 to 255. The default is 32.
Note See the ip pim border command to explicitly define a router on the edge of
a PIM domain rather than using the scope argument.
interval
interval
(Optional) Specifies an Auto-RP Announce message transmission interval in
seconds. The range is from 1 to 65,535. The default is 60.
bidir (Optional) Specifies that group range is advertised in PIM bidirectional (Bidir)
mode.
Release Modification
6.0(2)N1(1) This command was introduced.