Cisco Nexus 5600 Series - Page 335

331
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim bsr rp-candidate-policy
ip pim bsr rp-candidate-policy
To filter IPv4 Protocol Independent Multicast (PIM) bootstrap router (BSR) Candidate-RP messages that
are based on a route-map policy, use the ip pim bsr rp-candidate-policy command. To disable filtering,
use the no form of this command.
ip pim bsr rp-candidate-policy policy-name
no ip pim bsr rp-candidate-policy [policy-name]
Syntax Description
Command Default Disabled
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines You can specify the RP and group addresses, and whether the type is Bidir or ASM with the match ip
multicast command in a route-map policy.
This command requires the LAN Base Services license.
Examples This example shows how to filter Candidate-RP messages:
switch(config)# ip pim bsr rp-candidate-policy my_bsr_rp_candidate_policy
This example shows how to disable message filtering:
switch(config)# no ip pim bsr rp-candidate-policy
Related Commands
policy-name Route-map policy name.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim rp Displays information about PIM RPs.