Cisco Nexus 5600 Series - Page 337

333
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim event-history
ip pim event-history
To configure the size of the IPv4 Protocol Independent Multicast (PIM) event history buffers, use the ip
pim event-history command. To revert to the default buffer size, use the no form of this command.
ip pim event-history {assert-receive | bidir | cli | hello | join-prune | null-register | packet |
pim-internal | rp | vrf} size buffer-size
no ip pim event-history {assert-receive | bidir | cli | hello | join-prune | null-register | packet |
pim-internal | rp | vrf} size buffer-size
Syntax Description
Command Default All history buffers are allocated as small.
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
assert-receive Configures the assert receive event history buffer.
bidir Configures the Bidir event history buffer.
cli Configures the CLI event history buffer.
hello Configures the hello event history buffer.
join-prune Configures the join-prune event history buffer.
null-register Configures the null register event history buffer.
packet Configures the packet event history buffer.
pim-internal Configures the PIM internal event history buffer.
rp Configures the rendezvous point (RP) event history buffer.
vrf Configures the virtual routing and forwarding (VRF) event history buffer.
size Specifies the size of the buffer to allocate.
buffer-size Buffer size is one of the following values: disabled, large, medium, or small. The
default buffer size is small.
Release Modification
6.0(2)N1(1) This command was introduced.