Cisco Nexus 5600 Series - Page 344

340
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim jp-policy
ip pim jp-policy
To filter IPv4 Protocol Independent Multicast (PIM) join-prune messages that are based on a route-map
policy, use the ip pim jp-policy command. To disable filtering, use the no form of this command.
ip pim jp-policy policy-name [in | out]
no ip pim jp-policy [policy-name]
Syntax Description
Command Default Disabled; no filter is applied for either incoming or outgoing messages.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines The ip pim jp-policy command filters messages in both incoming and outgoing directions. To specify
filtering only incoming messages, use the optional in keyword; to specify filtering only outgoing
messages, use the optional out keyword. When you enter the command with no keywords, that is no
explicit direction, the system rejects further configurations if given with explicit direction.
Use the ip pim jp-policy command to filter incoming messages. You can configure the route map to
prevent state from being created in the multicast routing table.
You can specify group, group and source, or group and RP addresses to filter messages with the match
ip multicast command.
This command requires the LAN Base Services license.
Examples This example shows how to filter PIM join-prune messages:
switch(config)# interface ethernet 2/2
switch(config-if)# ip pim jp-policy my_jp_policy
This example shows how to disable filtering:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim jp-policy
policy-name Route-map policy name.
in Specifies that the system applies a filter only for incoming messages.
out Specifies that the system applies a filter only for outgoing messages.
Release Modification
6.0(2)N1(1) This command was introduced.