Cisco Nexus 5600 Series - Page 346

342
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim log-neighbor-changes
ip pim log-neighbor-changes
To generate syslog messages that list the IPv4 Protocol Independent Multicast (PIM) neighbor state
changes, use the ip pim log-neighbor-changes command. To disable messages, use the no form of this
command.
ip pim log-neighbor-changes
no ip pim log-neighbor-changes
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to generate syslog message that list the PIM neighbor state changes:
switch(config)# ip pim log-neighbor-changes
This example shows how to disable logging:
switch(config)# no ip pim log-neighbor-changes
Related Commands
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
logging level ip pim Configures the logging level of PIM messages.