Cisco Nexus 5600 Series - ip pim sparse-mode

353
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim send-rp-announce
Usage Guidelines The scope, and interval, and bidir keywords can be entered once and in any order.
The ip pim auto-rp rp-candidate command is an alternative form of this command.
This command requires the LAN Base Services license.
Examples This example shows how to configure a PIM Auto-RP candidate RP:
switch(config)# ip pim send-rp-announce ethernet 2/1 group-list 239.0.0.0/24
This example shows how to remove a PIM Auto-RP candidate RP:
switch(config)# no ip pim send-rp-announce ethernet 2/1 group-list 239.0.0.0/24
Related Commands Command Description
ip pim auto-rp
rp-candidate
Configures a PIM Auto-RP candidate RP.
show ip pim interface Displays information about PIM-enabled interfaces.