Cisco Nexus 5600 Series - Page 416

412
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip mroute summary
show ip mroute summary
To display summary information about IPv4 multicast routes, use the show ip mroute summary
command.
show ip mroute summary [count | software-forwarded] [vrf {vrf-name | all}]
show ip mroute [group] summary [software-forwarded] [vrf {vrf-name | all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display summary information about IPv4 multicast routes:
switch(config)# show ip mroute summary
IP Multicast Routing Table for VRF "default"
Total number of routes: 1
Total number of (*,G) routes: 0
Total number of (S,G) routes: 0
Total number of (*,G-prefix) routes: 1
Group count: 0, rough average sources per group: 0.0
count (Optional) Displays only route counts.
software-
forwarded
(Optional) Displays software-switched route counts only.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
group (Optional) Specifies a group address for a route.
Release Modification
6.0(2)N1(1) This command was introduced.