Cisco Nexus 5600 Series - Page 420

416
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip pim df
show ip pim df
To display information about the designated forwarders (DFs) for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim df command.
show ip pim df [rp-or-group] [vrf {vrf-name | all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about PIM DFs:
switch(config)# show ip pim df
rp-or-group (Optional) RP or group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.