Cisco Nexus 5600 Series - Page 457

453
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ipv6 pim policy statistics neighbor-policy
show ipv6 pim policy statistics neighbor-policy
To display information about the neighbor policy statistics for IPv6 Protocol Independent Multicast
(PIM6), use the show ipv6 pim policy statistics neighbor-policy command.
show ipv6 pim policy statistics neighbor-policy if-type if-number
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 policy statistics:
switch(config)# show ipv6 pim policy statistics neighbor-policy ethernet 2/2
C: No. of comparisions, M: No. of matches
route-map rmap2 permit 10
match ipv6 multicast group ff1e::/128 C: 0 M: 0
Total accept count for policy: 2
Total reject count for policy: 0
switch(config)#
if-type Interface type. For more information, use the question mark (?) online help function.
if-number Interface or subinterface number. For more information about the numbering syntax
for your networking device, use the question mark (?) online help function.
Release Modification
5.0(3)N1(1) This command was introduced.