Cisco Nexus 5600 Series - Page 460

456
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ipv6 pim rp-hash
show ipv6 pim rp-hash
To display information about the RP-hash values for IPv6 Protocol Independent Multicast (PIM6), use
the show ipv6 pim rp-hash command.
show ipv6 pim rp-hash group [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 RP-hash values:
switch(config)# show ipv6 pim rp-hash
PIM6 Hash Information for VRF "default"
PIM6 RPs for group ff1e::0001, using hash-length: 126 from BSR: 0001::0001
RP 0002::0001, hash: 1329585728 (selected)
show ip igmp snooping explicit-tracking
----------------------------------------
switch# show ip igmp snooping explicit-tracking vlan 33
IGMPv3 Snooping Explicit-tracking information
Source/Group Intf Reporter Uptime Last-Join Expires
1.1.1.1 232.1.1.1 Eth2/1 3.3.3.3 00:01:33 00:04:27
switch(config)#
group Group address for the RP lookup.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.