Cisco Nexus 5600 Series - Page 468

464
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show routing ipv6 multicast clients
show routing ipv6 multicast clients
To display information about IPv6 multicast routing clients, use the show routing ipv6 multicast clients
command.
show routing ipv6 multicast clients [client-name]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about IPv6 multicast routing clients:
switch(config)# show routing ipv6 multicast clients icmpv6
IPv6 Multicast Routing Client information
Client: icmpv6, client-id: 2, pid: 3742, mts-sap: 282
Shared-memory: icmpv6, wants notifications
Protocol is join-group owner
Join notifications: sent 1, fail 0, ack rcvd 1
Prune notifications: sent 0, fail 0, ack rcvd 0
RPF notifications: sent 0, fail 0, ack rcvd 0
Delete notifications: sent 0, fail 0, ack rcvd 0
Clear mroute notifications: sent 0, fail 0
Add route requests: rcvd 0, ack sent 0, ack fail 0
client-name (Optional) One of the following multicast routing client names:
• m6rib
• icmpv6
• ipv6
• static
• pim6
Release Modification
5.0(3)N1(1) This command was introduced.