Show Commands
show ip pim oif-list
MCR-76
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim oif-list
To display information about IPv4 Protocol Independent Multicast (PIM) interfaces for a group, use the
show ip pim oif-list command.
show ip pim oif-list group [source] [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display IPv4 PIM interfaces for a group:
switch(config)# show ip pim oif-list 232.0.0.0
PIM OIF-List for VRF default
(*, 232.0.0.0/8)
Incoming interface: Null0, RPF nbr 0.0.0.0
Timeout interval: 66 secs left
Oif-list (count: 0):
Timeout-list (count: 0):
group Group address.
source (Optional) Source address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
default Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
management Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Release Modification
5.0(3)N1(1) This command was introduced.
4.1(3) Changed output to include vPC information.
To Next Page
Loading...
