Cisco Nexus 5600 Series - Page 82

Show Commands
show ip pim policy statistics auto-rp
MCR-78
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim policy statistics auto-rp
To display information about the Auto-RP policy statistics for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim policy statistics auto-rp command.
show ip pim policy statistics auto-rp {rp-candidate-policy | mapping-agent-policy} [vrf
{vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 PIM policy statistics:
switch(config)# show ip pim policy statistics auto-rp rp-candidate-policy
rp-candidate-
policy
Specifies candidate-RP messages.
mapping-
agent-policy
Specifies mapping agent messages.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
default Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
management Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Release Modification
5.0(3)N1(1) This command was introduced.