2-7
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 2 PIX 501
Replacing a Lithium Battery
To replace the lithium battery, perform the following steps:
Step 1 Remove the chassis cover as described in the “Removing the Chassis Cover” section on page 2-4.
Step 2 Use a flathead screwdriver to slide the battery out of the metal clip on the circuit board (see Figure 2-8).
Step 3 Place the used battery aside and replace it with a new battery. Install the new battery writing side up.
Step 4 The battery snaps into place as you slide it into the battery slot.
Step 5 Replace the chassis cover as described in the “Replacing the Chassis Cover” section on page 2-5.
To Next Page
Loading...
Need help?
General
