Cisco SCE8000 User Manual

13
Table 2 lists commands for displaying the currently configured values and for configuring these parameters. It also lists the
command mode for each configuration command. All show commands are executed from the User Exec command mode.
Connecting the Management Interface
The SCE8000-SCM-E is equipped with one active management port. This is a GBE port with a RJ-45 interface. It is located in
slot# 1 of the Cisco SCE8000 chassis, and labeled Port1.
This port provides access from a remote management console to the Cisco SCE8000 through a LAN.
Cabling the Management Port
Step 1 Plug the Ethernet cable provided (with attached RJ-45 connector) into Port 1on the front panel of the SCE8000-SCM-E
(item #3 in Figure 9.)
Table 2 Initial Setup Configuration
Parameter show Command Configuration Command
Configuration Command
Mode
Management IP address
and subnet mask
show interface GigabitEthernet 1/1
ip address
ip address x.x.x.x subnet-mask GigabitEthernet
Interface configuration
Default gateway show ip default-gateway ip default-gateway x.x.x.x Global configuration
Hostname show hostname hostname host-name Global configuration
Authorization level
passwords
N/A enable password level level
[encryption-type] password
Global configuration
Clock show clock
show calendar
calendar set hh:mm:ss day month
year
clock read-calendar
or
clock set hh:mm:ss day month year
clock update-calendar
Privileged EXEC
Time zone show timezone clock timezone zone-name
offset-hours
Global configuration
Domain name server show hosts ip domain-lookup
ip domain-name domain-name
ip name-server server-address1
[server-address2] [server-address3]
Global configuration
RDR formatter
destination
show rdr-formatter destination rdr-formatter destination ip-address
port port-number
Global configuration

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English