Cisco SCE8000 User Manual

19
Viewing Configurations
When you enter configuration commands, this action immediately affects the SCE platform operation and configuration. The
configuration, referred to as the running-config, is saved in the SCE platform volatile memory and is effective while the SCE
platform is up. After reboot, the SCE platform loads the startup-config, which includes the nondefault configuration that was
saved by the user, into the running-config.
The SCE platform provides commands for:
• Viewing the running configuration with only user-configured (nondefault) values: show running-config
• Viewing the running configuration with all the SCE platform running configuration values, whether default or not: show
running-config all-data
• Viewing the startup configuration: show startup-config
After configuring the SCE platform, you may query for the running configuration using the command show running-config.
Step 1 At the Cisco SCE8000# prompt, type show running-config. The system shows the running configuration.
SCE8000#show running-config
#This is a general configuration file (running-config).
#Created on 12:06:13 UTC SUN May 11 2009
#cli-type 1
#version 1
no management-agent notifications notification-list 1417,1418,804,815,1404,1405,1406,1407,1408,400
no management-agent notifications notification-list 402,421,440,441,444,445,446,450,437,457
no management-agent notifications notification-list 3593,3594,3595,10040
snmp-server community "public" ro
RDR-formatter forwarding-mode multicast
RDR-formatter destination 10.56.96.26 port 33000 category number 1 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 2 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 3 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 4 priority 100
interface LineCard 0
connection-mode inline on-failure external-bypass
no silent
no shutdown
attack-filter subscriber-notification ports 80
replace spare-memory code bytes 3145728
interface GigabitEthernet 1/1
ip address 10.56.96.46 255.255.252.0
interface TenGigabitEthernet 3/0/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/1/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/2/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/3/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
exit
ip default-gateway 10.56.96.1
line vty 0 4
exit
management-agent property "com.pcube.management.framework.install.activation.operation" "Install"
management-agent property "com.pcube.management.framework.install.activated.package" "SCA BB"
management-agent property "com.pcube.management.framework.install.activated.version" "3.1.6 build 79"
management-agent property "com.pcube.management.framework.install.activation.date" "Sun May 11 08:44:04
GMT+00:00 2008"
flow-filter partition name "ignore_filter" first-rule 4 num-rules 32
flow-filter partition name "udpPortsToOpenBySw" first-rule 40 num-rules 21

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English