Cisco SG 300-10 User Manual

300 Series Managed Switches 4
Connecting Network Devices
To connect the managed switch to the network:
STEP 1 Connect the Ethernet cable to the Ethernet port of a computer,
printer, network storage, or other network device.
STEP 2 Connect the other end of the network Ethernet cable to one of the
numbered managed switch Ethernet ports.
The LED of the port lights if the device connected is active. Refer to
Features of the Cisco Small Business Managed Switch, page 10
for details about the different ports and LEDs on each switch.
STEP 3 Repeat Step 1 and Step 2 for each device you want to connect to
the managed switch.
NOTE Cisco strongly recommends using Cat5 or better cable for Gigabit
connectivity. When you connect your network devices, do not exceed
the maximum cabling distance of 100 meters (328 feet). It can take up to
one minute for attached devices or the LAN to be operational after it is
connected. This is normal behavior.
Power over Ethernet (PoE) Considerations
If your switch is one of the PoE models, consider the following:
As a PSE (Power Sourcing Equipment) device, the switch can deliver a
maximum of 15.4 Watts per PoE port to a PD (Powered Device).
2

Cisco SG 300-10 Specifications

General

Model	SG 300-10
Ports	10
Port Type	Gigabit Ethernet
Form Factor	Desktop
Layer	Layer 3
PoE	No
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Management	Managed
MAC Address Table Size	8000 entries
VLANs	256
Quality of Service (QoS)	Supported
Security Features	802.1X
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%, non-condensing
Jumbo Frame Support	Yes (up to 9216 bytes)
Dimensions (W x D x H)	279.4 x 170.18 x 44.45 mm