Cisco SG300 series

US OFFICE:
TEL: +1 901 384 3575
FAX: +1 901 384 3574
EMEA OFFICE:
TEL: + 44 (0) 1793 230 343
FAX: + 44 (0) 1793 230 583
WYRESTORM NETWORKHD
SWITCH CONFIGURATION GUIDE
NetworkHD uses the following smart features of your switch.
Multicast Video
With multicast video only one instance of the video stream is transmitted onto the network and the clients in turn grab a
copy of the video from the network. Multicast video always uses UDP at the Transport layer.
IGMP Snooping
IGMP snooping is the process of listening to Internet Group Management Protocol (IGMP) network trac. The feature
allows a network switch to listen in on the IGMP conversation between hosts and routers.
Cisco SG300 & SG500 Series Switches
1. Enable Bridge Multicast Filtering Status in
Multicast > Properties

Cisco SG300 series Specifications

General

Series	SG300
Switch Type	Managed
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Dimensions	Varies by model
Weight	Varies by model
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Power Supply	Internal
Power Consumption	Varies by model
Port Type	Gigabit Ethernet
Layer	Layer 3
Form Factor	Rack-mountable, Desktop
Security Features	ACLs, 802.1X
Ports	Varies by model (8 to 52)
PoE	Available on some models
Switching Capacity	Varies by model (16 Gbps to 104 Gbps)
MAC Address Table Size	16K entries

Summary

Wyrestorm NetworkHD Switch Configuration Guide

Enable Bridge Multicast Filtering

Configure the switch to enable multicast filtering via the Multicast > Properties menu.

NetworkHD Switch Configuration Steps

Configure IGMP Snooping Status

Enable IGMP Snooping status within the Multicast > IGMP Snooping interface.

Set IGMP Snooping and Querier Parameters

Configure VLAN, IGMP Snooping, IGMP Querier status and version in the switch settings.

Restrict Forward All Ports

Set 'Forward All' ports to 'Forbidden' for incompatible devices on the network.

Save and Apply Switch Configuration

Ensure settings are saved to boot configuration before power cycling the switch.