Cisco SG300

Cisco SG300 Setup Guide
When used with ELAN Video Over IP products

Cisco SG300 Specifications

General

Port Type	RJ-45
Gigabit Ethernet	Yes
Power Supply	Internal
Jumbo Frame Support	Yes (up to 9216 bytes)
Model	SG300
Layer	Layer 3
Management	Web-based, CLI, SNMP
Dimensions	Varies by model
Weight	Varies by model
VLAN Support	Yes
Operating Temperature	32°F to 113°F (0°C to 45°C)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Relative Humidity	10% to 90% noncondensing
Input Voltage	100-240 VAC
Input Frequency	50-60 Hz
Power Consumption	Varies by model
Heat Dissipation	Varies by model
Security Features	ACLs
Warranty	Lifetime

Summary

Introduction

Cisco Feature Requirements

Lists essential features for the ELAN Video Over IP solution on the Cisco switch.

Connecting to the Switch Web GUI Interface

V2 Panel Description

Provides default login credentials and connection steps for the switch's web interface.

Activating Layer 3 Mode

Jumbo Frame Configuration

IGMP Snooping Setup

Bridge Video Over IP Filter Status

Configuration steps for enabling IGMP snooping by setting the "Bridge Video Over IP Filter Status".

IGMP Snooping Status and Querier

IGMP Snooping Advanced Settings

Turning OnOff POE

Apply and Save Settings

Changing Your Computer IP Address

Select TCPIPv4 Properties

Accessing and selecting the Internet Protocol Version 4 (TCP/IPv4) properties.

Set Static IP Address

Entering the fixed IP address, subnet mask, and default gateway for your computer.

Verify Connectivity

Accessing the Cisco switch's IP address via a web browser to confirm connection.