Cisco SG300 User Manual

Cisco SG300 SETUP GUIDE
04
www.elanhomesystems.com
Connecting to the switch Web GUI Interface
V2 Panel Description
To login into the Cisco network switch the factory default details are:
IP Address: 192.168.1.254
User: cisco
Password: cisco
In order to connect to the network switch your computer will need to be physically connected to the Cisco switch using a Ethernet
network cable. The computer must also be in the same IP range as the Cisco switch default IP address. If you are unsure how to update your
computer IP range follow the ‘Changing your computer IP address’ instructions at the rear of this guide.
1) Open your internet browser (Google Chrome, Mozilla, Internet Explorer etc)
2) Type the network switch default IP address into the web browser bar
3) Enter the default user name and password
Note: If the switch is not using the factory default settings you will need to know these login details or have to factory reset the unit.
For details how to factory reset the network switch please refer to the networks switch user manual.

Cisco SG300 Specifications

General

Port Type	RJ-45
Gigabit Ethernet	Yes
Power Supply	Internal
Jumbo Frame Support	Yes (up to 9216 bytes)
Model	SG300
Layer	Layer 3
Management	Web-based, CLI, SNMP
Dimensions	Varies by model
Weight	Varies by model
VLAN Support	Yes
Operating Temperature	32°F to 113°F (0°C to 45°C)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Relative Humidity	10% to 90% noncondensing
Input Voltage	100-240 VAC
Input Frequency	50-60 Hz
Power Consumption	Varies by model
Heat Dissipation	Varies by model
Security Features	ACLs
Warranty	Lifetime