Cisco SG300 User Manual

Cisco SG300 SETUP GUIDE
12
www.elanhomesystems.com
1) Connect your computer to your network switch using Ethernet cable
2) In the Windows toolbar navigate to ‘CONTROL PANEL’
3) Select ‘NETWORK AND INTERNET’
Changing your computer IP address to communicate with
the Cisco network switch
5) Select ‘NETWORK AND SHARING CENTER’
6) Under ‘View your Active Networks’ you can see connection types available.
The example below shows both LAN (local area connection) and Wireless.
Select ‘Local Area Connection’ as this is the method of communication you are using with the switch.

Cisco SG300 Specifications

General

Port Type	RJ-45
Gigabit Ethernet	Yes
Power Supply	Internal
Jumbo Frame Support	Yes (up to 9216 bytes)
Model	SG300
Layer	Layer 3
Management	Web-based, CLI, SNMP
Dimensions	Varies by model
Weight	Varies by model
VLAN Support	Yes
Operating Temperature	32°F to 113°F (0°C to 45°C)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Relative Humidity	10% to 90% noncondensing
Input Voltage	100-240 VAC
Input Frequency	50-60 Hz
Power Consumption	Varies by model
Heat Dissipation	Varies by model
Security Features	ACLs
Warranty	Lifetime