Need help?Do you have a question about the Cisco SG300-28MP and is the answer not in the manual?
Details on the three physical installation methods for the switch: flat surface, wall, or rack.
Instructions for connecting computers, printers, and other network devices to the switch using Ethernet cables.
Overview of switch management methods, including web-based interface and console port.
Guidance on diagnosing and resolving connectivity issues with the switch.
Procedure to reboot or reset the switch to its original factory default configuration.
General| Model | SG300-28MP |
|---|---|
| Type | Managed Switch |
| PoE Budget | 195 W |
| Switching Capacity | 56 Gbps |
| Forwarding Rate | 41.67 Mpps |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Warranty | Limited Lifetime |
| Power over Ethernet (PoE) | Yes |
| Layer | Layer 3 |
| Operating Temperature | 0 to 40°C |
| Power Supply | Internal |
| MAC Address Table Size | 16000 entries |
| Storage Temperature | -40 to 70°C |
| Relative Humidity | 10% to 90% (non-condensing) |
| Management | Web GUI, CLI, SNMP |
| Security Features | ACL |
| Ports | 24 x 10/100/1000 + 4 x combo Gigabit SFP |
| Dimensions (H x W x D) | 1.73 x 17.32 x 10.12 in (44 x 440 x 257 mm) |
| Jumbo Frame Support | 9216 bytes |
To Next Page
