Need help?Do you have a question about the Cisco SG350-52P and is the answer not in the manual?
General| Model | SG350-52P |
|---|---|
| Port Count | 52 |
| PoE Ports | 48 |
| Total PoE Power | 370W |
| PoE Budget | 370W |
| Gigabit Ethernet Ports | 52 |
| Layer | Layer 3 |
| Switching Capacity | 104 Gbps |
| Forwarding Rate | 77.38 Mpps |
| Rack Mountable | Yes |
| RAM | 512 MB |
| Flash Memory | 256 MB |
| VLAN Support | Yes |
| MAC Address Table Size | 16K |
| Power Supply | Internal |
| Operating Humidity | 10% to 90% non-condensing |
| Uplink Ports | 4 SFP |
| Jumbo Frame Support | Yes |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
Guidelines for optimal switch placement and environment.
Procedures for securely installing the switch in a standard rack.
Steps for mounting the switch on a wall.
Important notes regarding PoE power requirements and usage.
Steps and information needed before configuring the switch.
Steps for setup using the web interface.
Steps for setup using the command-line interface.
Detailed list of available switch models and their descriptions.
Descriptions of USB, Ethernet, SFP, and PoE ports.
Meaning of System, LINK/ACT, Gigabit, and PoE indicator lights.
Description of power and console ports on the rear.
Steps to test reachability using ping.
Solutions for power, Ethernet, and console connection problems.
Guidance on IP configuration, routing, and access time.
Links to Cisco support, communities, and contacts.
Links to firmware, open source, partner resources, and documentation.
To Next Page
