●
●
●
Configure Stack Settings on an SG350X
Switch
Objective
This article provides instructions on how to configure stack settings on your switch. Stacked
switches are then collectively managed as a single logical device. In some cases, stack ports
can become members in a stack of Link Aggregation Groups (LAGs) increasing the
bandwidth of the stack interfaces.
For further details on stacking, click here to view the article - What is Stacking?
Applicable Devices
SG350X Series
Software Version
2.2.5.68
Configure Stack Settings on a Switch
Connect the Switches
Step 1. Determine the stack that you would like to configure. The options are:
Chain — Each unit is connected to the neighboring unit, but there is no cable connection
between the first and last unit. The image below shows a chain topology of a four-unit stack:
Need help?
To Next Page
General
