Cisco SPA122 Setup And Troubleshooting Guide

Phone.com Setup and Troubleshooting Guide
Cisco SPA122 Analog Telephone Adapter (ATA) with Router
6 / 9 Revised: 30 October 2012
Call Blocking (cont.)
If you blocked a number by mistake:
● Dial [*][9] again if you are still on the call. You will hear: “This caller has been unblocked.”
● Or, visit the Call Logs section in your Phone.com Control Panel, then click “Call Blocking
Settings.”
Call Recording
As a Phone.com user, you have the ability to record incoming calls. However, please check your current
state and the other party’s state and Federal laws before using this feature.
● Dial [*][7] to start recording. You will hear: “Recording is now on.”
● Dial [*][7] again to stop recording. You will hear: “Recording is now off.”
To review the recording, visit the Call Logs section in your Phone.com Control Panel. Please allow a few
minutes after the call ends for the recording to be available.

Cisco SPA122 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Mbps Ethernet
Voice Protocol	SIP
Voice Codecs	G.711, G.726, G.729 A
Security	TLS
Power Supply	5V DC, 2A
Network Ports	1 x 10/100 Mbps
Fax Support	T.38 fax relay
Operating Temperature	0°C to 45°C
Storage Temperature	14 to 140°F (-10 to 60°C)
Humidity	10% to 90% noncondensing
Weight	0.16 kg