Need help?Do you have a question about the Cisco SPA112 and is the answer not in the manual?
Overview of indicators and controls on the top surface of the adapter.
Details the ports and connectors located on the rear of the adapter.
Guide to accessing and using the web interface for device setup and management.
Instructions for configuring the ATA using the Interactive Voice Response system.
Recommendations for placing the ATA on a flat surface.
Instructions and hardware recommendations for mounting the ATA on a wall.
General| Supported network protocols | IPv4, IPv6, ARP, DNS, SRV, DHCP, PPPoE, ICMP, TCP, UDP, RTP, RTCP, SNTP |
|---|---|
| DHCP client | Yes |
| VPN support | 802.1p |
| Security algorithms | SSL/TLS |
| Authentication method | SIP |
| Modem (RJ-11) ports | 2 |
| Ethernet LAN (RJ-45) ports | 1 |
| Voice codecs | G.711, G.726, G.729 |
| Certification | FCC, CE, ICES, A-Tick, RoHS, UL |
| Fax compatibility | T.38 |
| Output current | 2 A |
| Output voltage | 5 V |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| Storage temperature (T-T) | -25 - 70 °C |
| Operating temperature (T-T) | 0 - 45 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
Weight and Dimensions| Width | 101 mm |
|---|---|
| Height | 28 mm |
| Weight | 153 g |
To Next Page
