Amcom Cisco SX10 Quick Guide
Remote Control and the Home Screen
Remote Control
1. Volume and Zoom control.
2. Field selector / Cursor keys.
3. OK / Enter key.
4. Go back one step / Backspace.
5. Microphone mute / Unmute.
6. Place a call / Accept incoming call.
7. Reject incoming call / End call /
Cancel / Back to Home screen
(outside calls).
8. Keypad
Home Screen
A. Access Settings, Standby mode
and the Do No Disturb features.
B. Access the Camera Control menu.
C. Place a Call.
D. Share Content.
Place a Call
1. Select Call from the home
screen and press OK or press the
green Call button on the remote.
2. Use the Cursor keys to select the
Search or Dial eld, as outlined.
3. Press the corresponding keys on
the remote to enter a number.
4. Tap the green Call button to place
the call.
5. Press the red End Call button or
use the Cursor keys to select End.
6. Press OK to terminate the call.
Enable Do Not Disturb
1 2 3
4 5 6
7 8 9
*
0
#
.@
pqrs tuv wxyz
defabc
ghi jkl mno
1
2
4 5
7
8
A B
C D
Operating Tips
Use the Cursor controls to move about the
screen and press OK / Enter to open the
selected menu eld.
Use the Cancel key to exit a menu (and return to
the Home screen) undoing any changes.
Use the Back key to go just one step back.
1. Using the remote, select the eld
in the upper left corner of the
Home screen and press OK.
3
6
2. Select Available or Do Not Disturb.
3. Press OK to save and exit
the menu.
Operating Tips
Your system can be set to ignore
incoming calls, however, you may
still call others.
To Next Page
Need help?
General
