Cisco SX350 Series User Manual

Access Control
ACL Binding
587 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
26
STEP 5 Enter the following for input and output ACLs:
Input ACL
• MAC-Based ACL—Select a MAC-based ACL to be bound to the interface.
• IPv4-Based ACL—Select an IPv4-based ACL to be bound to the interface.
• IPv6-Based ACL—Select an IPv6-based ACL to be bound to the interface.
• Default Action—Select one of the following options:
- Deny Any—If packet does not match an ACL, it is denied (dropped).
- Permit Any—If packet does not match an ACL, it is permitted (forwarded).
NOTE Default Action can be defined only if IP Source Guard is not activated on the
interface.
Output ACL
• MAC-Based ACL—Select a MAC-based ACL to be bound to the interface.
• IPv4-Based ACL—Select an IPv4-based ACL to be bound to the interface.
• IPv6-Based ACL—Select an IPv6-based ACL to be bound to the interface.
• Default Action—Select one of the following options:
- Deny Any—If packet does not match an ACL, it is denied (dropped).
- Permit Any—If packet does not match an ACL, it is permitted (forwarded).
NOTE Default Action can be defined only if IP Source Guard is not activated on the
interface.
STEP 6 Click Apply. The ACL binding is modified, and the Running Configuration file is updated.
NOTE If no ACL is selected, the ACL(s) that is previously bound to the interface are unbound.

Cisco SX350 Series Specifications

General

Brand	Cisco
Model	SX350 Series
Category	Switch
Language	English