Cisco TelePresence IX5200 - Add Participants to Existing Call

9
User Guide
Cisco TelePresence IX5000 and IX5200
Produced: October 2015
Updated: November 2016
All contents © 2015, 2016
Cisco Systems, Inc. All rights reserved.
Add participants to an existing call
Conference Calls with Multiple Participants
Your video system may be
equipped with the capability to
intiate a video conference with
multiple participants.
•
The maximum number of
participants on a call depends
on the system conguration
and video infrastructure.
•
If you want to initiate an ad hoc
video conference, you must
call each participant one by
one. If you are the one who
initiated the conference you
will be able to terminate the
entire conference. The other
participants, however, may
only disconnect themselves
from the conference.
•
Depending on their endpoint
conguration, some
participants may be audio-only.
•
Ad hoc video conferencing is
not supported if your software
version is 8.1.2 or earlier. You
can add a maximum of one
audio-only participant to an
existing call.
•
Contact your voice support
team for more information
on supported conferencing
functionality.
About video
conferences
54
Select the caller
to drop and tap
Drop.
To remove a
participant, tap the
participant list (not
supported for ad hoc
conferences).
To enter a
number or URI,
tap Dial. To enter a
contact, tap Contact.
Enter the number, URI,
or directory entry, and
tap Call.
To add
a video
or audio
participant
to an existing
call, tap Add.
Tap Merge
to merge
the call.
The new call
is added to
the existing call, thus
creating a conference.
2 31