Cisco WAP131 - Verifying Hardware Installation

Cisco WAP131 Quick Start Guide 5
Verifying the Hardware Installation
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator lights.
NOTE If you need help resolving a problem, visit the Cisco Support
Community at www.cisco.com/go/smallbizsupport.
Label Activity Description
POWER
Off The Cisco WAP131 has no power.
Solid Green The Cisco WAP131 is powered on, booting, or in
normal operation with DC power supply.
Solid Blue The Cisco WAP131 is powered on, booting, or in
normal operation with PoE 802.at power supply.
Solid Amber The Cisco WAP131 is powered on, booting, or in
normal operation with PoE 802.af power supply.
Solid Red The Cisco WAP131 fails to boot with both
firmware images.
Flashing
(Green/Blue/
Amber)
The Cisco WAP131 is upgrading the firmware,
or is acquiring an IPv4 or IPv6 address.
WLAN
Off Wireless is disabled for both 2.4 GHz and 5 GHz.
Solid Green Wireless is enabled in concurrent mode. (The
intensity needs to be the same.)
Solid Amber Wireless is enabled with only 5 GHz in use.
Solid Blue Wireless is enabled with only 2.4 GHz in use.
Flashing Transmitting or receiving data.
LAN
Off No Ethernet link.
Solid Green Gigabit Ethernet link is active.
Solid Amber Fast Ethernet link is active.
Flashing Transmitting or receiving data.
5