Cisco WS-SUP720= - Supervisor Engine 720 - User Manual

CHAPTER
4-1
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide, Release 12.2SXF
OL-3999-08
4
Configuring a Supervisor Engine 720
This chapter describes how to configure a Supervisor Engine 720 in a Catalyst 6500 series switch. This
chapter contains these sections:
• Using the Bootflash or Bootdisk on a Supervisor Engine 720, page 4-2
• Using the Slots on a Supervisor Engine 720, page 4-2
• Configuring Supervisor Engine 720 Ports, page 4-2
• Configuring and Monitoring the Switch Fabric Functionality, page 4-2
Note • For complete syntax and usage information for the commands used in this chapter, refer to the Cisco
IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
• With a 3-slot chassis, install the Supervisor Engine 720 in either slot 1 or 2.
• With a 6-slot or a 9-slot chassis, install the Supervisor Engine 720 in either slot 5 or 6.
• With a 13-slot chassis, install the Supervisor Engine 720 in either slot 7 or 8.
Tip For additional information about Cisco Catalyst 6500 Series Switches (including configuration examples
and troubleshooting information), see the documents listed on this page:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html

Cisco WS-SUP720= - Supervisor Engine 720 Specifications