To Next Page
F
Frances HunterJul 26, 2025
How to configure TFTP server IP address on Cisco WS-C6506?
- LlopeztimothyJul 26, 2025
To specify the TFTP server address on a Cisco Switch, use the set vmps tftpserver ip_addr [filename] command.
How to configure TFTP server IP address on Cisco WS-C6506?
To specify the TFTP server address on a Cisco Switch, use the set vmps tftpserver ip_addr [filename] command.
How to resolve Cisco WS-C6506 unable to contact TFTP server?
If the Cisco Switch is unable to contact the TFTP server, enter a static route (using the set ip route command) to the TFTP server.
Why does my Cisco Switch say enable failed due to insufficient resources?
The Cisco Switch might not have sufficient resources to run the database. To fix this, increase the dynamic random-access memory (DRAM).
What to do if Cisco Switch dynamic port shuts down with more than 50 active hosts?
If a Cisco Switch dynamic port shuts down because more than 50 active hosts reside on it, reenable the shut-down dynamic port by entering the set port enable mod/port command.
What to do if Cisco WS-C6506 dynamic port shuts down in secure mode?
If a Cisco Switch dynamic port shuts down because VMPS is in secure mode and it is illegal for the host to connect to the port, you can reenable it using the set port enable mod/port command.
How to fix 'File vmps_configuration.db not found' on Cisco WS-C6506 Switch?
If the file “vmps_configuration.db” is not found on the TFTP server, check the filename of the VMPS database configuration file on the TFTP server and ensure that the permissions are set correctly.
General| Model | WS-C6506 |
|---|---|
| Product Type | Switch |
| Number of Slots | 6 |
| Operating System | Cisco IOS |
| Product Series | Catalyst 6500 |
| Ports | Depends on modules installed |
| Management | CLI, SNMP, Web |
