45-3
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 45 Configuring Unicast Flood Blocking
Configuring Unicast Flood Blocking on the Switch
This example shows how to disable unicast flood blocking on a port:
Console> (enable) set port unicast-flood 4/1 disable
WARNING: Trunking & Channelling will be disabled on the port.
Unicast Flooding is successfully disabled on the port 4/1.
Console> (enable)
Disabling Unicast Flood Blocking
To configure the switch to receive the unicast flood packets on a port, you must enable unicast flood
blocking.
To disable unicast flood blocking, perform this task in privileged mode:
This example shows how to disable unicast flood blocking on a port:
Console> (enable) set port unicast-flood 4/1 enable
Unicast Flooding is successfully enabled on the port 4/1.
Console> (enable)
Displaying Unicast Flood Blocking
To display unicast flood blocking information, perform this task in privileged mode:
This example shows how to display unicast flood blocking information for port 1 on module 4:
Console> (enable) show port unicast-flood 4/1
Port Unicast Flooding
---- ----------------
4/1 Disabled
Console> (enable)
Task Command
Disable unicast flood blocking on the desired
Ethernet ports to enable unicast flooding.
set port unicast-flood mod/port enable
Task Command
Display unicast flood blocking information per
port.
show port unicast-flood mod/port
To Next Page