Cisco WS-C6506 - Displaying Port Capabilities; Configuring the MAC Utilization Load Interval

20-6
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Displaying Port Capabilities
142 00-d0-02-94-4f-ff 5/4
42 00-d0-02-83-eb-fc 2/1
142 00-d0-02-83-eb-ff & 5/3
Total Matching CAM Entries Displayed = 3
=========================================================================
Displaying Port Capabilities
You can display the capabilities of any port in a switch using the show port capabilities [[mod][/port]]
command.
To display the capabilities of a specific port, perform this task in normal mode:
This example shows how to display the port capabilities for switch ports:
Console> (enable) show port capabilities 1/1
Model WS-X6K-SUP1A-2GE
Port 1/1
Type No Connector
Speed 1000
Duplex full
Trunk encap type 802.1Q,ISL
Trunk mode on,off,desirable,auto,nonegotiate
Channel yes
Broadcast suppression percentage(0-100)
Flow control receive-(off,on,desired),send-(off,on,desired)
Security yes
Membership static,dynamic
Fast start yes
QOS scheduling rx-(1p1q4t),tx-(1p2q2t)
CoS rewrite yes
ToS rewrite DSCP
UDLD yes
Inline power no
AuxiliaryVlan no
SPAN source,destination
COPS port group 1/1-2
Console> (enable)
Configuring the MAC Utilization Load Interval
These sections describe how to configure the MAC utilization load interval:
• Understanding How the MAC Utilization Load Interval Works, page 20-7
• Setting the MAC Utilization Load Interval, page 20-7
• Displaying MAC Utilization Statistics, page 20-7
• Clearing MAC Utilization Counters, page 20-9
Task Command
Display the capabilities of a specific port. show port capabilities [mod[/port]]