Cisco WS-C6506 User Manual

22-21
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 22 Administering the Switch
Logging System Information to a TFTP or rcp Server
This example shows how to enable system information logging and verify that it is enabled:
Console> (enable) set system info-log enable
Successfully enabled system information logging.
Console> (enable) show system info-log
System Logging Host File Interval
-------------- --------------- ----------------------------------- --------
Enabled - tftp:sysinfo 1440
Index System Command
----- ----------------------------------------------------------
Console> (enable)
Specifying show Commands for System Information Logging
You can specify up to 15 show commands whose output is periodically logged in a file on a specified
server. You must use a delimiting character on either side of the show command. You can enter only one
show command at a time.
You can specify the order in which the show command is executed by entering the position argument;
the valid values are from 1–15. The position argument is the number of the show command in the system
information logging index.
To specify the show commands whose output is logged in a file, perform this task in privileged mode:
This example shows how to specify a show command and verify that it is included in the system
information logging:
Console> (enable) set system info-log command $show version$
System command was successfully added to the list.
Console> (enable) set system info-log command $show module$
System command was successfully added to the list.
Console> (enable) set system info-log command $show environment$
System command was successfully added to the list.
Console> (enable) set system info-log command $show config$
System command was successfully added to the list.
Console> (enable) show system info-log
System Logging Host File Interval
-------------- --------------- ----------------------------------- --------
Enabled - tftp:sysinfo 1440
Index System Command
----- ----------------------------------------------------------
1 show version
2 show module
3 show environment
4 show config
Console> (enable)
Task Command
Step 1
Specify the show commands whose output is
logged.
set system info-log command
{command_string} [position]
Step 2
Verify that system information logging is enabled. show system info-log

Cisco WS-C6506 Specifications

General

Brand	Cisco
Model	WS-C6506
Category	Switch
Language	English