Cisco WS-C6506 - Clearing the IP Addresses Associated with Access Numbers

47-15
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 47 Configuring SNMP
SNMPv1 and SNMPv2c Enhancements in Software Release 7.5(1)
Console> (enable) set snmp access-list 2 172.20.60.7
Access number 2 has been updated with new IP Address 172.20.60.7
Console> (enable) set snmp access-list 2 172.20.60.7 mask 255.255.255.0
Access number 2 has been updated with existing IP Address 172.20.60.7 mask 255.255.255.0
Console> (enable)
This example shows how to display the SNMP configuration:
Console> (enable) show snmp access-list
Access-Number IP-Addresses/IP-Mask
------------- -------------------------
1 172.20.60.100/255.0.0.0
1.1.1.1/-
2 172.20.60.7/-
2.2.2.2/-
3 2.2.2.2/155.0.0.0
4 1.1.1.1/2.1.2.4
2.2.2.2/-
2.2.2.5/-
Console> (enable)
Clearing the IP Addresses Associated with Access Numbers
To clear the IP addresses that are associated with the access numbers from the CLI, perform this task in
privileged mode:
These examples show how to clear the IP addresses that are associated with the access numbers:
Console> (enable) clear snmp access-list 101
All IP addresses associated with access-number 101 have been cleared.
Console> (enable)
Console> (enable) clear snmp access-list 2 172.20.60.8
Access number 2 no longer associated with 172.20.60.8
Console> (enable)
Task Command
Step 1
Clear the IP addresses that are associated with the
access numbers.
clear snmp access-list access_number
IP_address [[IP_address] ...]
Step 2
Verify the SNMP configuration. show snmp access-list