16-10
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 16 Configuring NDE
Configuring NDE on the Switch
Clearing an NDE Collector
You can enter the clear mls nde command to clear both the primary and secondary collectors and disable
NDE. To clear a specific collector destination, specify the collector IP address and port number.
To clear an NDE collector, perform this task in privileged mode:
This example shows how to clear both the primary and secondary collectors:
Console> (enable) clear mls nde
Collector’s IP address cleared.
Secondary Collector IP address cleared.
Console> (enable)
This example shows how to clear a specific collector destination:
Console> (enable) clear mls nde 10.6.1.10 9939
Cleared Collector IP 10.6.1.10 port 9939
Console> (enable)
Configuring NetFlow on the MSFC
Note If the MSFC is not present you can only collect (and export) bridged-flow statistics (if the bridged-flow
statistics feature is enabled). You must enable NetFlow on the MSFC Layer 3 interfaces to support NDE
for routed and Layer 3-switched traffic.
Refer to these publications for more information about configuring NetFlow on the MSFC:
• http://www.cisco.com/en/US/docs/ios/12_1/switch/configuration/guide/switch_c.html, “NetFlow,”
at this URL:
http://www.cisco.com/en/US/docs/ios/12_1/switch/configuration/guide/xcdnfov.html
• Cisco IOS Switching Services Command Reference, Release 12.1, at this URL:
http://www.cisco.com/en/US/docs/ios/12_1/switch/command/reference/switch_r.html
These sections describe how to configure NetFlow on the MSFC:
• Enabling NetFlow, page 16-11
• Configuring the MSFC NDE Source Interface, page 16-11
• Configuring the NDE Destination, page 16-11
Task Command
Clear all NDE collectors or a specific NDE
collector.
clear mls nde {ip_address port}
To Next Page
Loading...
Need help?
General